XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX''"> Data Translated from the ANSYS Input File
The following sections describe which specific ANSYS card types can currently be read into Patran.
The ANSYS cards described in this document are the only cards read when importing an ANSYS input file into Patran. All non-supported cards will be ignored. When errors occur during the import of a supported card type, the card being processed may or may not be imported, depending on the severity of the problem encountered. An error message will be presented regardless of whether or not the offending card is actually imported.
Any references from supported cards to cards that were not imported (either due to not being a supported card type or due to serious import errors) will still be attempted. If this reference is required in Patran for the card currently being processed, it too will fail to import. For example, if there is a serious error on a N (node) card which causes it to not imported, then all elements attached to that node will also fail to import.
Supported Keywords
Node | Description |
N | Node |
NROT | Node Rotate |
Elements and Properties | Description |
ET | Element type |
EMOR | Additional element data |
EN | Element connectivity |
REAL | Select Real Constant Set |
R | Real Constant data |
RMOD | Modify Real Constant Sets |
RMOD | Add real constant data to Sets |
TYPE | Select Element type |
Loads and Boundary Conditions | Description |
D | Degree of Freedom constraints |
F | Force |
BFDE | Deletes nodal body force loads |
DDEL | Deletes degree of freedom constraints |
FDEL | Deletes force loads on nodes |
HFDE | |
SFED | Deletes surface loads from elements |
Materials | Description |
MAT | Select Material |
MP | Define Material Property Data |
MPTE | Defines a temperature table for material properties |
MPDA | Defines property data to be associated with the temperature table |
Setup and Solution Commands | Description |
/TIT | Define the Title |
/STI | Define the Subtitle |
/SOL | Enter the solution Processor |
SOLV | Solve |
/PRE | Enter the Preprocessor (PREP7) |
FINI | Finish |
/BAT | Run in Batch mode |
/NOP | Set no print option |
/EXI | Exit |
/COM | Comment |
/EOF | End of File |
KAN | Option |