Selects a dynamic load or an acoustic source to be applied in a transient or frequency response problem. (p. 66)

Controls echo (i.e., printout) of the Bulk Data. (p. 114), (p. 117)

Requests form of enthalpy vector output in transient heat transfer analysis (SOL 159). (p. 130)

Requests the form and type of gradient and flux output in heat transfer analysis. (p. 130)

Requests form of rate of change of enthalpy vector output in transient heat transfer analysis (SOL 159). (p. 130)

Selects the initial conditions for direct transient analysis (SOLs 27, 69, 99, 109, 129, and 159). (p. 75)

Selects an external static load set. (p. 66)

Sets the maximum number of output lines. (p. 114), (p. 117)

Selects a multipoint constraint set. (p. 50)

Selects the parameters used for nonlinear static analysis. (p. 123), (p. 133)

Requests the form and type of applied load vector output. (p. 130)

Selects a single-point constraint set to be applied. (p. 73)

Requests the form and type of single-point force of constraint vector output. (p. 130)

Delimits and identifies a subcase. (p. 121), (p. 135)

Defines a subtitle that will appear on the second heading line of each page of printer output. (p. 121)

Selects the temperature set to be used in either material property calculations or thermal loading in heat transfer and structural analysis. (p. 75)

Requests the form and type of temperature output. (p. 130)

Defines a character string that will appear on the first heading line of each page of MD Nastran printer output. (p. 106)

Selects integration and output time steps for nonlinear transient problems. (p. 128), (p. 133)